LS9
Firmware

  • Use the Editor with the supported firmware listed in the following table.

LS9 Compatibility

  • Files saved using later Editor or console versions cannot be loaded into earlier versions.
  • Please note that some types of USB flash memories cannot be used for firmware updates, or cannot be accessed from the LS9 at all.

Current Version Info

V1.16

Fixed Bug

  • Fixed a network port problem that was caused by the specific MAC addresses allocated to LS9. (All affected LS9s were already fixed before shipment.) It is no problem to upgrade LS9 from V1.15 to V1.16, however, there are no new functions added.
  • If you purchased a LS9 whose firmware is V1.16, please do not downgrade it to V1.15 or earlier because the Network port (for Studio Manager) cannot be used. An error message will appear when turning on the power. (For recovery, please re-install firmware V1.16.)

How to update the firmware

Before performing any firmware upgrade it is good practice to back-up console data to a USB memory device.

  1. Copy the following file to root directory of your USB memory.
    LS9Px_xx.PGM (x_xx shows the version number.)
  2. Insert your USB memory and power on.
  3. LS9 detects the file and show the following message.
    "Start Loading? CANCEL[DEC]/OK[INC]"
  4. Then press [INC] key to start updating the firmware.
  5. Wait until completing the update. LS9 automatically restarts and becomes ready to use.

Performance Limits and Specifications

They are the same as V1.10.

TOP