* This check sheet calculates if the total power consumption of the cards you have selected stays within the power supply limit of each host model. Please follow the guideline so that you won't damage the equipment.
Note
- Digital I/O card even which does not support 96kHz operation can handle 96kHz audio when "double channel mode" is set on the host machine. (Number of audio transmission channels halves in this mode.)
- When MY8-ADDA96 is set to AE96 mode, do not set the host DME64N to double channel mode (it will not operate correctly).
- In order to use three or four MY16-C cards, firmware V1.10 or later will be required.
- In order to use three or four MY16-C cards, a hardware upgrade will be required if the serial number written on
the upper surface of your DME64N is shown below.
KK, KL, KM, KN, KO, KP, KX, KY are the third and fourth digits of the serial number.
A fee is charged for the hardware upgrade.
For details, contact Yamaha customer support using the contact information located at the end of the "DME64N/24N
Owner's Manual".
- AVIOM16/o-Y1, AVY16-ES and MY16MADI64 are supported with the software V1.2 or later.
- For AudioService MY16MADI64, use four cards (one master card and three slave cards) as one set.
- Firmware V2.01 or later will be required in order to recognize MY16-CII card.
