DME-N/DME Satellite Firmware V3.11

New Features

• The following two commands have been added to the Remote Control Protocol.
  • GMUT: Obtaining mute condition
  • SWF: Stopping playback of a file in the WAV File Player
  Refer to the DME Remote Control Protocol Specifications V3.1 [PDF] for detailed information on the commands.

Fixed Bugs

• The message "Scene Recalling. Do not turn off!" is now displayed (the DME Satellite lights the front panel [SIGNAL] indicators consecutively in a clockwise direction.) until internal processing has been thoroughly completed to be ready to turn off the power when a scene is recalled. Never attempt to turn off the power until the message disappears.
• Fixed a problem in which audio was sometimes cut off when communication was broken between the group master and the slave.
• (DME64N/DME24N only) Fixed a problem in which characters in the Info page of the UTILITY screen were occasionally not displayed correctly when using Japanese characters.
• (DME Satellite only) Fixed a problem in which it seemed as if the second and subsequent remote controllers could be connected, when remotely controlling the DME Satellite via Ethernet.
• Fixed a problem in which the Delay Time parameters and some Gain parameters could not be occasionally controlled remotely from the external devices.

Precautions for updating the DME Satellite

• If the DME Satellite firmware is updated from versions V3.09 or earlier to V3.10 or later, the internal device updates will be run for about 30 seconds immediately after the first restart. Never attempt to turn off the power while any four (4) [SIGNAL] indicators out of eight (8) at the front panel are alternately flashing in process of updating.

System Requirements

Please refer to system requirements of DME Designer.