M7CL V3
Firmware

  • Use the Editor with the supported firmware listed in the following table.

M7CL V3 Compatibility

  • Files saved using later Editor or console versions cannot be loaded into earlier versions.
  • Please note that some types of USB flash memories cannot be used for firmware updates, or cannot be accessed from the M7CL at all.
  • If you intend on downgrading the M7CL-32/48 firmware V3 to V1 or V2, make sure to back up the internal data, then initialize the internal memory before updating.

Current Version Info

V3.04

Fixed Bugs

  • Fixed a problem in which the OUTPUT PATCH Recall Safe for a MIX/MATRIX channel became inactive, when the Recall Safe settings of ALL and WITH MIX/MATRIX SEND for the channel were enabled in the RECALL SAFE MODE popup window.
  • Fixed a problem in which the OUTPUT PATCH Recall Safe for a channel might have become active, even though the SAFE buttons were set to OFF, when the Recall Safe of ALL or OUTPUT PATCH for the other channel was enabled in the RECALL SAFE MODE popup window.
  • Fixed a problem in which the INSERT PATCH/DIRECT OUT Recall Safe for the INPUT channel became inactive when the following settings were made in the RECALL SAFE MODE popup window:
    • ALL for the INPUT channel was enabled in the SAFE PARAMETER SELECT field.
    • OUTPUT PATCH was enabled in the GLOBAL RECALL SAFE field.
  • Fixed a problem in which the INSERT PATCH/DIRECT OUT Recall Safe for the INPUT channel became inactive when the Recall Safe of ALL for the INPUT channel was enabled, and the scene, in which IN PATCH was selected using the Focus function, was recalled.
  • (M7CL-48ES only) Fixed a problem in which the INPUT channels 13 to 16 were not directly output to SLOT and OMNI OUT.
  • (M7CL-48ES only) Fixed a problem in which the direct output of channel 1 was output to the direct output destination of channel 13 when the direct output destination of the INPUT channels 1 and 13 were set to SLOT or OMNI OUT. The combination of INPUT channels 2 and 14, 3 and 15, or 4 and 16 also applies.

Improvement

  • The setting of OUTPUT PATCH in the GLOBAL RECALL SAFE field now takes priority over the corresponding settings (OUTPUT PATCH, output patch of DIRECT OUT, output patch of INSERT PATCH) in the SAFE PARAMETER SELECT field in the RECALL SAFE MODE popup window.

TOP