Print This Page

TXn Firmware V1.30 for Win 7/Vista/XP

Important Notice

  • Use the Editor with the supported firmware listed in the following table.

Amp Editor/XMV Firmware/TXn Firmware/ACD1 Firmware Compatibility

Amp Editor XMV Firmware TXn Firmware ACD1 Firmware
1.3.1 1.20, 1.12 1.30, 1.11(*), 1.10(*) 1.13, 1.12, 1.11, 1.10
1.3.0 1.12
1.2.1 -
1.2.0, 1.1.0 - 1.11, 1.10
1.0.1, 1.0.0 - 1.02, 1.01, 1.00 -

(*) When Partial Lock is selected on the Amp Editor, the TXn is set to Full Lock.

Main Revisions and Enhancements

New Features

  • Added Partial Lock to the “Utility” screen -> [Front Panel Operation], enabling locking of panel operations other than mute, attenuation, and library recall.
  • Added PIN Code to the “Utility” screen -> [Front Panel Operation]. Only those privy to the PIN Code can cancel the lock and initialize internal memory.
  • Added a short-cut for the Speaker Processor component in the library screen.
  • Added four new Remote Control commands:
    Refer to “TXn/ACD1 Remote Control Protocol Specifications Version 1.12 2nd edition”.

Fixed Bugs

  • Fixed a problem in which remote control performance was slow when receiving continuous control data for multiple commands.
  • Fixed a problem where when the same scene as the current scene was recalled, and the "SCN" command was not transmitted from TXn in remote control.

System Requirements

OS Windows 7 (64 or 32 bit) Windows Vista (64 or 32 bit) Windows XP (Professional / Home Edition; SP2 or later)
CPU 32bit: 2GHz or higher Intel Core/Pentium/Celeron family processor;
64bit: Intel 64 compatible processor
2GHz or higher Intel Core/Pentium/Celeron family processor 1.5GHz or higher Intel Core/Pentium/Celeron family processor
Memory 32bit: 1GB or more;
64bit: 2GB or more
1GB or more 512MB or more
HDD 300 MB or more
Display 1024 x 768 pixels or higher; High Color 16-bit or higher
Other Ethernet (100Base-TX/10Base-T) port

former version information.

TXn Firmware V1.11 for Win

Fixed Bugs

  • Fixed a problem in which the alert message "FAN Failed" would very occasionally appear, even though the fan was working properly, when the power was turned on or switched from Standby to On.
  • Fixed a problem in which measuring of the impedance may not have been possible when "Calibration" of "Calibration by Pilot Tone" was executed in the Signal Chain Check function.

TXn Firmware V1.10 for Win

New Feature
  • The GAIN function was added to each slot input channel, which enables you to easily make input signal levels consistent between analog and digital (slot) inputs.
  • The oscillator settings are now excluded from scene functions, so that the settings are not affected by scene recall operations.
Fixed Bugs
  • Fixed a problem in which the "Power Amp Mode Changed" alert message appeared when starting up the amplifier while the AMP Mode was set to other than STEREO.
  • Fixed a problem in which the start-up process might be initiated on the amplifier when a synchronization operation was performed from Amp Editor by the [Amp Editor->Device] direction.

License agreement and software

TXn Firmware V1.30 for Win 7/Vista/XP

You also need to download these files.

Return to Top