Print This Page

AG DSP Controller V1.2.0 Mac OS X 10.13-10.7

Important Notice

  • You can reset the AG06/03 to factory default setting by following procedure.
    A. By using AG DSP Controller
    1. Connect the AG06/03 directly to the computer by using a USB cable, and turn on the AG06/03
    2. Start AG DSP Controller on the computer
    3. Press "EXPERT" button to go to Expert mode
    4. Select "DEFAULT" from LOAD Menu
    B. By using only the AG06/03
    1. Connect the AG06/03 directly to the computer by using a USB cable
    2. Turn on the AG06/03 while pressing and holding down the "COMP/EQ" button.

Main Revisions and Enhancements

V1.1.0 to V1.2.0

  • Now supports OS 10.13.

V1.1.0

Improvement

  • When the edit box of the parameter is clicked, the edit box changes to overwritten selected state.

Fixed bugs

  • The ON/OFF parameters of COMP/EQ, EFFECT and AMP SIM are not stored on the AG when the AG DSP CONTROLLER is disconnected, if those are changed on the AG while the AG DSP CONTROLLER is connected.
  • Fixed a problem in which the GR meter of COMP is in motion when the effect is started.
  • Fixed a problem in which the EQ graph is shown as flat under certain conditions.
  • Fixed a problem in which EQ parameters are not overwritten even if the Save operation was carried out when EQ was OFF.

System Requirements

OS OS X 10.7、10.8、10.9、10.10、10.11、macOS 10.12.x/ 10.13.x
CPU Intel Dual Core
Memory 1GB or more
HDD 100MB or more
Display 1280 x 800px or more

License agreement and software

AG DSP Controller V1.2.0 Mac OS X 10.13-10.7

Upgrade Instruction

Return to Top