Print This Page

Dante-MY16-AUD Firmware V4.0.8.6

Important Notice

  • The firmware is dedicated to Dante-MY16-AUD. Please make sure not to apply it to Dante-MY16-AUD2.
  • In order to install this firmware V4.0.8.6, your Dante-MY16-AUD's firmware version must be V3.7.2.2 or later. If your firmware version is earlier than V3.7.2.2, Please update it with the following steps. The previous firmware versions are found here.
    For any firmware updates below, please make sure to put a check on "Override Device Matching" in Dante Firmware Update Manager. Otherwise, you cannot find the target device.

[For update from V3.4.0 through V3.7.1.11]
Please update it to V3.7.2.2 first, and then update again to V4.0.8.6 in order to avoid known update issues.

[For update from earlier than V3.4.0]
At first, please update it to V3.4.0. And then update that to V3.7.2.2, and further update to V4.0.8.6 in order to avoid known update issues.

Please use the appropriate version of Dante Firmware Update Manager.

Please do not use the EEE function (*) of network switches in a Dante network.

Although power management should be negotiated automatically in switches that support EEE, some switches do not perform the negotiation properly. This may cause EEE to be enabled in Dante networks when it is not appropriate, resulting in poor synchronization performance and occasional dropouts.

Therefore we strongly recommend that:

  1. If you use managed switches, ensure that they allow EEE to be disabled. Make sure that EEE is disabled on all ports used for real-time Dante traffic.
  2. If you use unmanaged switches, make sure to not use network switches that support the EEE function, since EEE operation cannot be disabled in these switches.

* EEE (Energy Efficient Ethernet) is a technology that reduces switch power consumption during periods of low network traffic. It is also known as Green Ethernet and IEEE802.3az.

  • Dante products for Yamaha mixers and processors have a built-in Dante module, and its firmware needs to be updated accordingly.
  • When Dante-MY16-AUD V3.3.9 or later is used in conjunction with CL series, please update the CL/Rio firmware to V1.11 or later.
  • When Dante-MY16-AUD is used in conjunction with CL series, please update the Dante-MY16-AUD firmware to V3.3.9 or later.

Main Revisions and Enhancements

V4.0.8.6

New Functions

  • Now supports the HA remote operation in Dante domains.
  • MY16-AUD card can be added to the DDM (Dante Domain Manager) server supported by Audinate.

Note: In order to effectively utilize the functions described above, use Dante Controller v4.0.6.5 or later.

License agreement and software

Dante-MY16-AUD Firmware V4.0.8.6

Return to Top