Print This Page

DME-N and ICP1 firmware V3.56 for Win (Previous version)

Important Notice

  • The hardware specification for DME Firmware V3.5x or earlier differs from the one for Firmware V3.8x or later. Therefore firmware V3.5x or earlier cannot be upgraded to V3.81 or later. Also, firmware V3.81 or later cannot be downgraded to V3.5x or earlier. (This does not apply to the SP2060 or ICP1.)
    If you need to upgrade your DME from V3.55 or earlier to V3.81 or later, please contact your Yamaha dealer.
  • Save an up-to-date DME project file (*.daf). Don't update unless an up-to-date &quote;.daf&quote; file has already been saved on your computer. Without the &quote;.daf&quote; file, you will not be able to restore DME operation.
  • When DME64N/24N units running firmware version 3.5x or earlier and DME64N/24N or DME Satellite units running firmware versions 3.81 or later are combined in the same device group, DME64N/24N units running firmware version 3.5x or earlier cannot be designated as the group master.

Fixed Bugs

  • Fixed the following problems which were caused when using MY8-AE96S:
    The sound was sometimes cut off.
    "SLOTx Sync Err" message was repeatedly displayed and the sound was periodically interrupted.
  • (DME64N only) Fixed a problem in which noise was generated if the sampling frequency of the sound output side was set to 48kHz or 44.1kHz and the sampling frequency of the sound input side was set to 96kHz or 88.2kHz when two DME64N devices were cascade connected.
  • Fixed a problem in which sound and display might not match when the Remote Control command was transmitted to the DME device continuously.

License agreement and software

DME-N and ICP1 firmware V3.56 for Win (Previous version)

You also need to download these files.

You are recommended to download these files.

Return to Top