M7CL V3 Firmware V3.54
Important Notice
- [Caution]: With the V3.54 firmware, there are cases where M7CL may freeze when using GEQ in the Virtual Rack 5-8. The freezing may occur when GEQ is rack mounted or the setting is changed by scene recall. Use the firmware V3.55 or later.
M7CL V3 Firmware V3.55
- Files saved using later Editor or console versions cannot be loaded into earlier versions.
- Please note that some types of USB flash memories cannot be used for firmware updates, or cannot be accessed from the M7CL at all.
- If you intend on downgrading the M7CL-32/48 firmware V3 to V1 or V2, make sure to back up the internal data, then initialize the internal memory before updating.
M7CL V3 Compatibility (Win)
| M7CL Editor | Studio Manager V2 Host | M7CL Firmware | EtherSound Firmware(*2) |
|---|
| 3.5.4 |
2.3.1 |
3.54 |
0C18 |
| 3.5.1 | 3.52(*1) |
| 3.51 |
| 3.5.0 | 3.50 |
| 3.0.4 | 3.04 | 0C16 |
| 3.0.3 | 3.03 |
| 3.0.0 | 3.02, 3.01 |
M7CL V3 Compatibility (Mac)
| M7CL Editor | Studio Manager V2 Host | M7CL Firmware | EtherSound Firmware(*2) |
|---|
| 3.5.4 |
2.3.4 |
3.54 |
0C18 |
| 3.5.1 | 3.52(*1) |
| 3.51 |
| 3.5.0 | 3.50 |
| 3.0.5 | 3.04 | 0C16 |
(*1) only for M7CL-48,32, (*2) only for the M7CL-48ES
Known problem
- With the V3.54 firmware, there are cases where M7CL may freeze when using GEQ in the Virtual Rack 5-8. The freezing may occur when GEQ is rack mounted or the setting is changed by scene recall.
Fixed bugs
- (M7CL-48ES only) Fixed a problem in which the Direct Out signal may have stopped when the wordclock was changed.
- Increased the stability of remote control of an external head amplifier. Through this, the following conditions have been eliminated or minimized:
- Termination of communication.
- M7CL recognized AD8HR to be AD824.
- The actual gain amount differs from the display.
- Fixed a problem within the Flex15GEQ, when paste or recall was performed to FLEX15GEQ and to which a different band from copied data or recall data was set, the setup was not reflected correctly.
Return to Top
