Print This Page

R Remote V4.5.0 for Mac macOS 10.13-OS X 10.9

Important Notice

  • You need to install the Dante Controller before using the R Remote software.
  • In the "System Preferences" -> "Network" screen, if using manually configured settings, leave the router item blank or enter the IP address of the connected router. When using with Dante Controller, there are cases in which the device can no longer be found correctly.
  • In some cases, the scroll bar in the R Remote device selection area is not shown. If you want to see it temporarily, two finger swipe on the Trackpad, one finger swipe on the Magic Mouse or operate scroll wheel on a mouse over the device selection area. If you want it to be shown at all times, go to "System Preferences" -> "General," and set the "Show scroll bar" setting to [Always].

R Remote compatibilities

Main Revisions and Enhancements

New Features

  • Now supports remote control of the Rio3224-D2 and Rio1608-D2.

System Requirements

In order to use R Remote, you'll need the computer equipped with the following conditions.

OS Mac OS X 10.9.5/ 10.10.x/ 10.11.x, macOS 10.12.x/ 10.13.x
CPU Intel Core i3 or higher
HDD 120MB or more
Connector An Ethernet connector (1000BASE-T or higher recommended.)
Other Dante Controller must be installed, Ethernet cable (CAT5e or better), Network switch (with gigabit Ethernet support)

License agreement and software

R Remote V4.5.0 for Mac macOS 10.13-OS X 10.9

Return to Top