Print This Page

R Remote V2.0.0 for Mac (Previous version)

Important Notice

  • You need to install the Dante Controller before using the R Remote software.
  • In the "System Preferences" -> "Network" screen, if using manually configured settings, leave the router item blank or enter the IP address of the connected router. When using with Dante Controller, there are cases in which the device can no longer be found correctly.

R Remote / R Series Firmware Compatibilities

R Remote Rio/Ri/Ro/RMio Firmware Set RSio Firmware Set
3.0.0 3.10 1.00
2.0.0 3.00  
1.0.0(Win Only) 1.70  

Main Revisions and Enhancements

Main Revisions and Enhancements

  • First release version.

System Requirements

In order to use R Remote, you'll need the following items.
  • A computer equipped with the following conditions
OS Mac OS X 10.9.5, 10.10.x
CPU Intel Core i3/i5 or higher
HDD 120MB or more
Connector An Ethernet connector (1000BASE-T or higher recommended.)
Other Dante Controller must be installed.
  • Ethernet cable (CAT5e or better)
  • Network switch (with gigabit Ethernet support)
  • R series (Rio/Ri/Ro) units (up to 24 units) with firmware V3.00 or later

NOTICE

  • In some cases, the scroll bar in the R Remote device selection area is not shown. If you want to see it temporarily, two finger swipe on the Trackpad, one finger swipe on the Magic Mouse or operate scroll wheel on a mouse over the device selection area. If you want it to be shown at all times, go to "System Preferences" -> "General," and set the "Show scroll bar" setting to [Always].

License agreement and software

R Remote V2.0.0 for Mac (Previous version)

You also need to download these files.

You are recommended to download these files.

Return to Top