Print This Page

Yamaha LAN Monitor

Which switches can be used with this software?

SWP1 and SWR series are the main focus for this software. Some other Yamaha switches, router, and wireless AP are also supported, but with limited functionality. Some 3rd party switches will be discovered, but will not be controlled.

Was this FAQ helpful to you?

How does the software discover the switches in the network?

A Layer 2 protocol is used, without any need to take care of the IP addresses. Just select the correct network interface on your computer, then the switches and Dante devices will be discovered automatically.

Was this FAQ helpful to you?

Can each switch be given a name for easy recognition?

Yes, they can be named in the “Device Settings” of Yamaha LAN Monitor.

Was this FAQ helpful to you?

Can the software be used to edit settings in Dante devices?

No, just monitoring Dante settings such as bandwidth used, latency, and sample-rate. Dante Controller software can be used on the same computer for editing Dante device settings.

Was this FAQ helpful to you?

Why do some Dante devices have 2 different MAC addresses and register 2 times in the “Connected Devices” list?

Some Dante enabled devices such as Yamaha CL-series, QL-series and R-series register twice in the Connected Devices list of Yamaha LAN Monitor. This is normal behavior, as these devices have 2 MAC addresses: one for the Dante port and one for device management.

Was this FAQ helpful to you?

MCP1 controllers do not appear in the “Connected Devices” list.

Start Yamaha MTX-MRX Editor software, or send a PING command to MCP1 and press the Update button in the Connected Devices list of Yamaha LAN monitor. MCP1 will be discovered and displayed.

Was this FAQ helpful to you?

Return to Top