Print This Page

Dante Accelerator Driver V2.0.0 for Mac (Previous version)

Important Notice

  • You cannot double-click to open the uninstaller because of a specification change of Gatekeeper on Mac OS X 10.9.5. In that case, control-click the uninstaller icon in Finder, and select "Open" from the top of the contextual menu that appears. Once you open it, you can double-click to open it after that.
  • You need to update the Dante Accelerator Firmware to V2.0.0.

Dante Accelerator Firmware/Driver Compatibility

Firmware(mac) Driver(mac)
2.5.0 2.5.1/2.5.0
2.0.0-2 2.0.0
1.0.1-2 1.0.1
1.0.0 1.0.0

Main Revisions and Enhancements

Main Revisions and Enhancements

V1.0.1 to V2.0.0

Specification Changes

  • Now supports Dante Redundancy. (The secondary port became available.
  • Changed the system requirements to the following. OS X 10.7.5 or 10.8.x.

Fixed Bug

  • Solved the problem in which the Dante Accelerator for which Pull up/Pull down is set to enable does not work properly in OS X 10.8.

Known Issue

  • None.

System Requirements

OS Mac OS 10.7.5/ 10.8.x/ 10.9
PC a 2009 Mac Pro or later
RAM 6GB
HDD 64M Cache (recommended) 7200rpm
PCIe SLOT x4 lane or above
* Please refer to system requirements of NUAGE

former version information.

Dante Accelerator firmware V2.0.0

Specification Changes
  • Now supports Dante Redundancy. (The secondary port became available.)
Fixed Bug
  • Solved the problem in which the Dante Accelerator for which Pull up/Pull down is set to enable does not work properly in OS X 10.8.
Known Issue
  • None.

Dante Accelerator firmware V1.0.1

Specification Changes
  • Disabled the Pull up/Pull down settings in OS X 10.8 which does not support Pull up/Pull down.
  • This firmware does not support Dante Accelerator Driver V1.0.0 for Mac. V1.0.1 or later is required for use.
Fixed Bug
  • Solved the problem in which the noise might occur when changing the Pull up/Pull down settings in Mac OS X 10.6 or 10.7.
Known Issue

To customers planning to use the card from OS X 10.6 or 10.7 to 10.8.

  • The Dante Accelerator for which Pull up/Pull down is set to enable does not work properly in OS X 10.8. Before installing, set the Pull up/Pull down setting to “None”

Dante Accelerator firmware V1.0.0

  • The initial release version.

License agreement and software

Dante Accelerator Driver V2.0.0 for Mac (Previous version)

Return to Top