Print This Page

Dante Accelerator Firmware V1.0.1-2 (Previous version)

Dante Accelerator Firmware/Driver Compatibility

Firmware Driver
Win Mac
2.5.0-2 2.0.2 2.5.1/2.5.0
2.0.0-2 2.0.1 2.0.0
1.0.1-2 1.0.1 1.0.1
1.0.0 1.0.1 1.0.0

Dante Accelerator Firmware/Driver Compatibility

Firmware(mac) Driver(mac)
2.5.0 2.5.1/2.5.0
2.0.0-2 2.0.0
1.0.1-2 1.0.1
1.0.0 1.0.0

Main Revisions and Enhancements

Version Information

(V1.0.1 to V1.0.1-2)

Fixed Bug

  • Solved a problem in which an error message was displayed and the Dante Firmware Update Manager for Windows could not be installed. Updating to V1.0.1-2 is not necessary if you are already using V1.0.1 since only the installer was fixed and the firmware was not changed.

System Requirements

OS Windows 8 Windows 7 (SP1) Mac OS 10.6.8/ 10.7.5/ 10.8.x
PC 32-bit : Intel Core i5 / Intel Core i7 (2nd Generation "Sandy Bridge" Core i7 or later recommended
64-bit : Intel Core i5 / Intel Core i7 (2nd Generation "Sandy Bridge" Core i7 or later recommended
32-bit : Intel Core i5 / Intel Core i7 (2nd Generation "Sandy Bridge" Core i7 or later recommended
64-bit :Intel Core i5 / Intel Core i7 (2nd Generation "Sandy Bridge" Core i7 or later recommended
Mac Pro (Early 2009) or later
RAM 8GB 6GB
HDD 64M Cache (recommended) 7200rpm 64M Cache (recommended) 7200rpm
PCIe SLOT x4 lane or above x4 lane or above
*Please refer to system requirements of NUAGE

former version information.

Dante Accelerator firmware V2.0.0

Specification Changes
  • Now supports Dante Redundancy. (The secondary port became available.)
Fixed Bug
  • Solved the problem in which the Dante Accelerator for which Pull up/Pull down is set to enable does not work properly in OS X 10.8.
Known Issue
  • None.

Dante Accelerator firmware V1.0.1

Specification Changes
  • Disabled the Pull up/Pull down settings in OS X 10.8 which does not support Pull up/Pull down.
  • This firmware does not support Dante Accelerator Driver V1.0.0 for Mac. V1.0.1 or later is required for use.
Fixed Bug
  • Solved the problem in which the noise might occur when changing the Pull up/Pull down settings in Mac OS X 10.6 or 10.7.
Known Issue

To customers planning to use the card from OS X 10.6 or 10.7 to 10.8.

  • The Dante Accelerator for which Pull up/Pull down is set to enable does not work properly in OS X 10.8. Before installing, set the Pull up/Pull down setting to “None”

Dante Accelerator firmware V1.0.0

  • The initial release version.

License agreement and software

Dante Accelerator Firmware V1.0.1-2 (Previous version)

Return to Top